Supplies:
Tools needed
hammer
eyelet tools
hammering mat
eyelets |
|
Directions:
- Step #1
You will need to
punch a hole for the eyelet to go into. Using our all in one
tool, pick a punch head as close as possible to the size of the
barrel of the eyelet. Place on tool handle. Tap back of handle
lightly with a hammer. Make sure you are using a hammering mat
to protect your work surface. Figuer 1
- Step #2
Place eyelet into
the hole. And turn project over so the barrel of the eyelets
is sticking out the back side of the project. Figure 2 & 3
- Step #3
We are going to
set the eyelet. Put the setting head onto your tool handle.
It is the one with the pointed end. Place point of setter into
the middle of eyelet barrel. Tap the back of the tool handle
lightly with your hammer remembering to stay on your hammering
mat. The barrel of the eyelet will start to flare out. On to
the next step. Figure 5 & 6
- Step #4
We are going to
put the finishing head onto our tool. It is the flat one. place
tool over back of eyelet and hammer lightly to finish flattening
out the back of your eyelet. Figure 7 & 8
Now you are finished. Fig.9 & 10
|
|
Fig. 1 |
Fig. 2 |
Fig. 3 |
Fig. 4 |
Fig. 5 |
Fig. 6 |
Fig. 7 |
Fig. 8 |
Fig. 9 |
Fig. 10 |
|
