|
1)
This easy-to-make Halloween card starts with stamping the skeleton
stamp on a piece of black card stock with clear embossing ink.
Emboss the skeleton with the White Sparkle embossing powder.
Then trim around the skeleton leaving a black border of about
1/8 inch.
2) Stamp the Boo! stamp on black cover stock with clear
embossing ink. Emboss with the 14K Pumpkin embossing powder.
Trim around the image, leaving a 1/8" border on this also.
3)
The next step is to stamp the Spider Web stamp in the lower left
hand corner of the folded sheet of yellow-orange cover stock
leaving a 1/4" to 3/8" border. You may wish to pre-draw
a very light line showing where you will be placing the spider
web stamp on the gold paper. You may also draw this line around
the entire card so you will know where to line up your
black marker.
4) Assembly: Line up the Boo! image at an angle in the
upper left hand corner and attach it to the card with 2-sided
tape when you have it at the angle you want. Next, line up the
skeleton image so it overlaps the Boo! image and extends down
to the lower left hand part of your card. Attach it to the card
with foam tape so it appears to be jumping out at you.
5)
Final touches: Using a fine line marker, extend the lines of
the spider web stamp out to form a border around your card. Where
the Boo! stamp overlaps the line, stop and leave a little space
for emphasis. And, you are done with a spooky skeleton card for
Halloween!
|
